The tire shredder is a specially designed shredding equipment for tires with larger volume, thickness and hardness. It can effectively shred rubber tires, bias tires, radial tires, and car tires. After the tires are shredded, they can be ground into powder by a pulverizer for reprocessing. The tire shredder can directly shred any steel wire tire with a diameter of less than 2000mm without any prior treatment of the tire, and can directly shred the bezel steel wire. Greatly improve production efficiency, but also save labor.
Everyone knows that if you want a car to run fast and have a long life, it can only be achieved if the daily maintenance work is done well, and the same tire shredder is the same. Our factory has specialized in the production and research of tire shredders for many years. We tell you from the experience that users and friends are absolutely not allowed to treat tire shredders without raising them. Otherwise, it will not only save investment costs, but also reduce the service life of tire shredders. Therefore, it is imperative to pay attention to the maintenance of tire shredders. In order to save the time of users and friends, we have summarized some maintenance knowledge of using tire shredders, hoping to help everyone.
Tire Shredder Applicable Materials
1. The tire shredder should be placed in a ventilated position to ensure the heat dissipation of the motor and prolong its life.
2. The bearings should be filled with lubricating oil regularly to ensure the lubricity between the bearings.
3. Regularly check the cutter screws. After the new tire shredder is used for 1 hour, use tools to tighten the screws of the moving knife and the fixed knife to strengthen the fixation between the blade and the knife holder.
4. In order to ensure the sharpness of the knife incision, the knife should be checked frequently to ensure its sharpness and reduce unnecessary damage to other parts caused by the dullness of the knife edge.
5. When replacing the tool, the gap between the movable knife and the fixed knife: 0.8MM for crushers above 20HP, and 0.5MM for crushers below 20HP. The thinner the recycled material, the larger the gap can be.
6. Before the second start, the remaining debris in the machine room should be removed to reduce the starting resistance. The inertia cover and pulley cover should be opened regularly to remove the ash outlet under the flange, because the powder discharged from the tire shredder room enters the shaft bearing.
7. The machine should be well grounded.
8. Regularly check whether the tire shredder belt is loose, and adjust it in time.
The maintenance of tire shredder equipment cannot be taken lightly at any time, and it must not be abandoned halfway. If you insist on regular maintenance and timely maintenance, you will be able to find the effect of tire shredder work over time. We guarantee tire shredders. The operation of the crusher equipment will become more and more smooth, the production efficiency will become higher and higher, and the service life will be much longer than expected, so it is recommended that you carry out this work to the end.
